| Step | | Procedure & Parts & Tools |
| 1 |
|
CUT THE BAD PLUG OFF THE CORD.
|
| 2 |
|
CAREFULLY CUT THRU THE WIRE COVERING ON THE POWER CORD. BE CAREFUL NOT TO CUT ANY OF THE WIRES. NOTE: IF ANY WIRES ARE CUT, CUT THAT PART OF THE CORD OFF AND START OVER.
|
| 3 |
|
THE WIRES ARE NOW VISIBLE.
|
| 4 |
|
CAREFULLY CUT THE WIRE COVERING ON EACH WIRE. CUT ABOUT A HALF INCH OFF.
| Wire cutters |
|
|
| 5 |
|
THE 3 WIRES SHOULD NOW LOOK LIKE THIS.
|
| 6 |
|
SET THE POWER CORD ASIDE. LOOSEN THE 2 SCREWS ON THE CORD CLAMP ON THE NEW PLUG.
| Screwdriver-phillips |
|
|
| 7 |
|
THE NEW PLUG HAS 3 PARTS SHOWN HERE.
|
| 8 |
|
LOOSEN THE 3 SCREWS ON THE PRONG PART OF THE PLUG.
| Screwdriver-phillips |
|
|
| 9 |
|
PULL THE PRONG PART OF THE PLUG OFF THE BOTTOM PART OF THE PLUG.
|
| 10 |
|
SLIDE THE BOTTOM PART OF THE PLUG ON THE POWER CORD.
|
| 11 |
|
LOOSEN THE 3 SCREWS ON THE PRONG PART OF PLUG. INSERT EACH WIRE INTO THE PLUG AND TIGHTEN THE SCREWS. NOTE: GREEN WIRE TO GREEN SCREW, WHITE WIRE TO SILVER SCREW AND BLACK WIRE TO THE BRASS SCREW.
| Screwdriver-phillips |
|
|
| 12 |
|
THE PRONG PART OF THE PLUG SHOULD LOOK LIKE THIS.
|
| 13 |
|
SLIDE THE BOTTOM PART OF PLUG UP TO CONNECT IT TO THE PRONG PART OF THE PLUG.
|
| 14 |
|
TIGHTEN THE 3 SCREWS ON THE PRONG PART OF PLUG.
| Screwdriver-phillips |
|
|
| 15 |
|
PUT THE 2 PARTS OF THE CORD CLAMP ON THE POWER CORD AT THE BASE OF THE PLUG AND TIGHTEN THE 2 SCREWS.
| Screwdriver-phillips |
|
|
| 16 |
|
PUT THE 2 PARTS OF THE CORD CLAMP ON THE POWER CORD AT THE BASE OF THE PLUG AND TIGHTEN THE 2 SCREWS.
|
| 18 |
|
PLUG THE MACHINE IN AND TURN ON POWER. NOTE: IF MACHINE DOESN'T POWER ON, GO BACK AND RECHECK WIRE IS CONNECTED CORRECTLY AND TIGHTLY.
|